China Electric Power Fittings suppliers Terminal Fitting is mainly used for substation of electrical appliances from electrical equipment (such as transformers, circuit breakers, isolation switch, transformers). Due to the two types of common electrical equipment as copper and aluminum, the bus lead is divided into aluminum strand or steel core aluminum strand, so the equipment line clip is divided into aluminum equipment wire clamp and copper aluminum excessive equipment. Two series of wire clamps. Terminal Fitting is divided into bolt type depending on the installation method and structural form. Two types of compression. Each form of a line clip is divided into zero, 45 degrees, 90 degrees from the angle of the line and the mounting electrical device terminal. The grip of the equipment wire clamp on the wire is not less than 10 percent of Xi’an calculation, but the bolt type is suitable for a wire diameter greater than 49mm, which is not less than 3%. The linear resistance of the wire holder is not larger than the resistance of the oriental wire, and the temperature rise is lower than the temperature rise of the wire.China Electric Power Fittings suppliers website:http://www.chinaelectrictelecommunicate.com/electric-power-fittings/